Ibm BladeCenter T Type 8720 Manual de usuario descargar pdf (Pagina 72)

Release

latch

(open)

Release

latch

(open)

Ethernet

switch

module

Fibre

Channel

switch

module

Filler

module

Filler

module

Removing an I/O module

Use the following instructions to remove an I/O module or filler module from the

rear of the BladeCenter T unit.

1. Press the release lever at the end of the release latch and pull the latch to the

open position. The I/O module moves slightly out of the bay.

2. Slide the I/O module out of the I/O-module bay and set it aside.

3. Within 1 minute, install another I/O module or filler module into the bay.

Installing an I/O module

Complete the following steps to install an I/O module into the rear of the

BladeCenter T unit.

1. Press the release lever at the end of the release latch and pull the latch to the

open position.

2. Insert the I/O module into the selected I/O-module bay.

3. Push the I/O module into the bay until it stops. The release latch moves slightly

toward the closed position.

4. Close the release latch until it locks into position.

62 BladeCenter T Type 8720 and 8730: Hardware Maintenance Manual and Troubleshooting Guide

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 179 180

Sin comentarios

Ibm BladeCenter T Type 8720 Manual de usuario Pagina 72