Ibm 2196 Manual de usuario Pagina 191

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 208
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 190
Starting and using the Configuration/Setup Utility
program
To start the Configuration/Setup Utility program:
1. If your computer is already on when you start this procedure, you
must shut down the operating system, turn off the computer, wait a
few seconds until all in-use lights go off. (Do not use Ctrl+Alt+Del to
restart the computer.)
2. Press and hold F1 while turning on the computer. If you have not set a
password, the Configuration/Setup Utility program menu is displayed.
If you have set a password, the Configuration/Setup Utility program
menu is not displayed until you type your password at the prompt
and press Enter.
Note that the Configuration/Setup Utility program is started automatically
when a hardware configuration change is detected during POST.
The menu you see on your computer might look slightly different from the
menu shown here, but it will operate the same way.
Note the the Configuration/Setup Utility program is started automatically
when a hardware configuration change is detected during POST.
Configuration/Setup Utility
Select Option:
System Summary
Product Data
Devices and I/O Ports
Start Options
Date and Time
System Security
Advanced Setup
ISA Legacy Resources
Power Management
Save Settings
Restore Settings
Load Default Settings
Exit Setup
3
Vista de pagina 190
1 2 ... 186 187 188 189 190 191 192 193 194 195 196 ... 207 208

Comentarios a estos manuales

Sin comentarios