Ibm 2196 Manual de usuario descargar pdf (Pagina 123)

Adding and replacing system board components

9-9

Upgrading the system memory

Your system board has two system memory module sockets: DIMM 0, and DIMM 1.

These sockets hold Dual Inline Memory Modules (DIMMs) that contain 3.3V single-

or double-sided synchronous DRAM (SDRAM). You can install up to a maximum of

256 MB of system memory into these sockets. For information about supported

memory configurations, see “Memory module placement” on page A-1.

Installing memory modules

To install a DIMM:

1. Locate the memory retaining clips at both ends of the socket. Pivot the

memory retaining clips outward.

2. Locate the two notches on the DIMM and the two tabs on the socket. Align

the DIMM with the socket. Make sure the notches and tabs align.

3. Press the DIMM into the socket until the clips lock into the DIMM

Note:

The DIMM socket is slotted to ensure proper

installation. If you insert a DIMM but it does not fit

easily into the socket, you may have inserted it

incorrectly. Turn the DIMM around and try to insert

it again.

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 207 208

Sin comentarios

Ibm 2196 Manual de usuario Pagina 123