IBM Security Camera 343 Manual de usuario Pagina 130
- Pagina / 187
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
118 xSeries 343 Hardware Maintenance Manual
PCI Installation Tips
Some common PCI tips are listed here.
• Reserve interrupts (IRQs) and/or memory addresses specifically for ISA add-in cards. This
prevents PCI add-in cards from trying to use the same settings ISA add-in cards are using. Use
the SSU to keep track of ISA add-in card resources.
• Certain drivers may require interrupts that are not shared with other PCI drivers. The SSU can
be used to adjust the interrupt numbers for PCI devices. For certain drivers, it may be
necessary to alter settings so that interrupts are not shared.
Problems with Application Software
If you have problems with application software, do the following:
• Verify that the software is properly configured for the system. See the software installation and
operation documentation for instructions on setting up and using the software.
• Try a different copy of the software to see if the problem is with the copy you are using.
• Make sure all cables are installed correctly.
• Verify that the server board jumpers are set correctly. See Chapter 5.
• If other software runs correctly on the system, contact your vendor about the failing software.
• If the problem persists, contact the software vendor’s customer service representative for help.
Bootable CD-ROM Is Not Detected
Check the following:
Is the BIOS set to allow the CD-ROM to be the first bootable device?
- Hardware Maintenance Manual 1
- Contents 3
- Contents v 5
- Figures 6
- Contents vii 7
- Contents ix 9
- CAUTION 10
- Part I: User’s Guide 13
- 1 Introduction 17
- Before You Begin 18
- 2 Chassis Description 19
- Features and Specifications 20
- Environmental Specifications 21
- Chassis Feature Location 22
- Back Panel 25
- Internal Chassis Features 26
- Processor 27
- PCI Riser Slots 27
- SCSI Controller 27
- Network Controller 28
- Network Teaming Features 28
- Keyboard and Mouse 29
- RJ45 Serial Port 30
- Security 31
- Riser Boards 34
- Power Supplies 35
- DC Power Subsystem 35
- Introduction 36
- Interface Requirements 36
- Peripheral Bay 37
- Hard Drive Tray 37
- Cooling Subsystem 38
- Server Management Summary 39
- Electronic Emission Notices 41
- Using BIOS Setup 46
- Setup Menus 47
- Main Menu 48
- Advanced Menu 49
- PCI Configuration Submenu 50
- USB Function Submenu 50
- Security Menu 51
- Server Menu 52
- Console Redirection Submenu 53
- Boot Menu 54
- Exit Menu 55
- Upgrading the BIOS 56
- Recovering the BIOS 58
- Changing the BIOS Language 59
- What You Need to Do 59
- Running the SSU from the CD 59
- Starting the SSU 60
- Customizing the SSU 61
- Launching a Task 62
- SEL Manager Add-in 62
- SDR Manager Add-in 63
- FRU Manager Add-in 63
- FRU/SDR Load Utility 64
- Parsing the Command Line 66
- Displaying Usage Information 66
- Displaying a Given Area 66
- Using Specified CFG File 67
- Updating the BMC Firmware 68
- Updating the FRU/SDR Files 69
- Running the SCSI Utility 69
- 5 Upgrading the Hardware 71
- 6 Upgrading the Chassis 71
- Equipment Rack Precautions 72
- Replacing Hard Disk Drives 76
- Working Inside the System 78
- To Connect: To Disconnect: 79
- Internal Chassis Layout 82
- Figure 16. Installing DIMMs 83
- Removing a Processor 88
- Upgrading the Chassis 85 97
- Upgrading the Chassis 87 99
- Replacing Fans 100
- Replacing a 40 mm Fan 101
- 7 Technical Reference 103
- Serial Ports 105
- Configuration Jumpers 106
- Figure 39 107
- Figure 40 107
- FRU List 108
- Technical Reference 97 109
- Failure Information 110
- Note: G=Green, R=Red 111
- POST Error Beep Codes 118
- PC Doctor Symtom to FRU 120
- Equipment Log 122
- Warnings 111 123
- C Solving Problems 124
- Solving Problems 113 125
- Monitoring POST 126
- Power Light Does Not Light 127
- Cannot Connect to a Server 129
- Problems with Network 129
- PCI Installation Tips 130
- Problem Determination Tips 131
- Getting Information 132
- Software Service and Support 133
- Hardware Service and Support 133
- E Safety Addendum 136
- Electrical Safety 137
- Safety Inspection Guide 139
- Grounding Requirements 141
- Statement 2 143
- Statement 3 143
- Safety Addendum 133 145
- Instrução 2 146
- Instrução 3 146
- Safety Addendum 135 147
- CUIDADO 148
- Safety Addendum 137 149
- Safety Addendum 139 151
- Safety Addendum 141 153
- Safety Addendum 143 155
- Safety Addendum 145 157
- Safety Addendum 147 159
- Notice n° 2 161
- Notice n° 3 161
- Safety Addendum 151 163
- Hinweis 2 164
- Hinweis 3 164
- Safety Addendum 153 165
- Avviso 2 167
- Avviso 3 167
- Safety Addendum 157 169
- Safety Addendum 159 171
- Safety Addendum 161 173
- Safety Addendum 163 175
- Declaración 2 177
- Declaración 3 177
- >82 kg 179
- F Product Notices 180
- Trademarks 181
- Important Notes 181
- Index 171 183
- Index 173 185
- Part Number: 59P2178 187
© 2020, manymanuals.es. Todos los derechos reservados | 0.058 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales