IBM ATM OC-3c Manual de usuario Pagina 59
- Pagina / 140
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
ATM Port Setup 8-7
Figure 8-7
ATM Port Setup Screen
The screen shows the following fields:
Port
Identifies the selected port.
Port Speed
Shows the speed of the port connection.
Port State
Allows you to turn the port on and off. If
you wish to allow traffic to pass through this port,
select the
Enable
option. To prevent traffic passing
through the port, select
Disable
.
Link State
Indicates whether the communication link
connected to the port is capable of transmitting and
receiving traffic. The states are:
Present
— the link is capable of transferring traffic; if
the ports are also turned on (
enabled
).
Not Available
— the link is not capable of transferring
traffic.
If the link is
Not Available
and both devices are
powered-up and operational, there is a physical
problem with your connection. For information about
the cause of problems and possible solutions, see
Table 8-2.
To transmit traffic the port must have a
Port State
of
Enabled
and the
Link State
must be
Present
.
Table 8-2
Link State Troubleshooting Summary
Problem Solution
The connectors at either
end of the link have come
loose, or been accidently
pulled out.
Ensure that the cable is
securely connected to the
port at both ends of the link.
The port at the far end of
the link is
disabled
.
Enable the far end port.
If you have fiber cable
with connectors that can
be reversed; the two
connectors at one end of
the fiber cable may be
plugged into the port the
wrong way around.
Check that each cable
connector is connected to the
correct port socket. You may
need to reverse the TX and RX
cable connectors at one end of
the link.
The cable is caught under
a heavy object or become
bent out of shape.
Remove any obstructions and
straighten out any kinks in the
cable.
The connector itself is
physically damaged.
Contact your repair center for
advice. Refer to Appendix E,
“Technical Support and
Service” for more details.
- User’s Guide 1
- Introduction 7
- Terminology 7
- Conventions 8
- Related Documentation 9
- ATM Benefits 11
- ATM Module Features 12
- Figure 2-1 13
- Network Layer Architecture 13
- Upper Layer Protocols 14
- What is LAN Emulation (LANE)? 14
- LAN Emulation Components 15
- Figure 2-2 16
- Joining the ELAN 17
- Figure 2-3 18
- ATM Adaptation Layer (AAL) 20
- ATM is Service Transparent 21
- ATM is Connection-oriented 21
- Figure 2-6 22
- Connection Terminology 22
- Figure 2-7 23
- ATM Interfaces 24
- Figure 2-9 25
- UNI Management Entities 25
- Figure 2-10 26
- ATM Cell Structure 26
- Physical Layer 27
- What is a Virtual LAN (VLAN)? 29
- Creating Inter-switch VLANs 29
- Figure 3-2 30
- VLAN to ELAN Mapping 30
- Figure 3-3 31
- Planning Your Network 33
- ATM Configuration Rules 34
- Figure 4-1 36
- ONFIGURATION 37
- Campus Configuration 38
- Campus Configuration 5-3 39
- Figure 5-3 40
- Resilient Link Configuration 40
- Following Safety Information 41
- Nebezpečenstvo: 42
- Device Support 43
- Pre-installation Procedure 43
- Installation 44
- Post-Installation Checks 45
- LED Summary 46
- Checking the Power Supply 47
- CCESSING 49
- ANAGEMENT 49
- Figure 7-1 50
- Screen Map 50
- Logging On 51
- Logging Off 52
- Figure 8-1 53
- Management Screen Map 53
- Configuring an ATM Port 54
- Configuring an ATM Port 8-3 55
- Figure 8-3 56
- ATM LEC Setup Screen 56
- Displaying all VLANs 57
- ATM Port Setup 58
- ATM Port Setup 8-7 59
- Mapping Far End MAC Addresses 60
- Displaying an ATM Connection 62
- Setting Up Resilient Links 63
- Upgrading Software 64
- Error Messages 65
- Status Messages 66
- ONITORING 67
- Statistics Overview 68
- ATM VLAN LEC Status 71
- ATM VLAN LEC Status 9-7 73
- ATM VLAN LEC Status 9-9 75
- ATM Physical Layer Statistics 76
- Figure 9-5 77
- Physical Layer Statistics 77
- NFORMATION 81
- Safety Notices A-3 83
- Safety Notices A-5 85
- Safety Notices A-7 87
- PECIFICATIONS 91
- C: ATM M 92
- ATM Cable Specification C-3 93
- Using LEDs 96
- Identifying the Problem 97
- Figure D-1 98
- Troubleshooting Flow Diagram 98
- Figure D-2 99
- Figure D-3 100
- ATM Port Setup Screen 100
- Figure D-4 101
- ATM Port Statistics 101
- Figure D-5 102
- ATM VLAN LEC Status Screen 102
- Identifying the Problem D-9 103
- ROUBLESHOOTING 104
- Identifying the Problem D-11 105
- Identifying the Problem D-13 107
- Is the LEC Operational Now? 108
- — Go to step 25 108
- ELAN Configuration Problems 109
- Figure D-8 110
- ATM VLAN LEC Setup 110
- Solving Known Problems 111
- Power Supply Problems 112
- Solving Known Problems D-19 113
- Cable Connection Problems 114
- ATM Problems 115
- VLAN or ELAN Problems 116
- Solving Known Problems D-23 117
- ECHNICAL 119
- RADEMARKS 121
- ARRANTIES 121
- Statement of Limited Warranty 122
- Warranty Service 123
- Extent of Warranty 123
- Limitation of Liability 124
- Electronic Emission Notices 125
- European Union (EU) Statement 126
- (VCCI) Statement Class B 127
- Information To The User 127
- IBLIOGRAPHY 135
Relacionado con productos y manuales para Redes IBM ATM OC-3c
Redes IBM Z10 EC Manual de usuario
(67 paginas)
(67 paginas)
Redes IBM Z10 Manual de usuario
(67 paginas)
(67 paginas)
Redes IBM xSeries 330 Manual de usuario
(158 paginas)
(158 paginas)
Redes IBM BC-203 Manual de usuario
(52 paginas)
(52 paginas)
Precor TRM 800 manuals
Owner’s manuals and user’s guides for Sports and recreation Precor TRM 800.
We providing 1 pdf manuals Precor TRM 800 for download free by document types: User Manual
Comentarios a estos manuales