IBM TOTALSTORAGE DS4500 Manual de usuario

IBM TotalStorage DS4500 Storage Subsystem Fibre Channel Cabling Guide 򔻐򗗠򙳰 Attention This document contains important changes to the requir

Configuring the drive loops The procedure and illustrations in this section show how to connect one group of four storage expansion

For the location of the ports on the storage expansion enclosure ESM board, see Figure 10. In InOut OutStorage expansion enclosureESM b

If you want to connect more storage expansion enclosures into drive loops A and B, continue with Step 3; otherwise, go to “Connec

Connecting a redundant drive loop to the DS4500 Use the following procedure to connect a redundant drive loop to the DS4500 Storag

2. Connect drive loop B to the DS4500 Storage Subsystem, as shown in Figure 15. Starting with the first storage expansion enclos

Leave the In port on the right ESM board on the first storage expansion enclosure in storage expansion enclosure group 2 and the

Trademarks The following terms are trademarks of International Business Machines Corporation in the United States, other countries, or

Installing an SFP module and fibre channel cable 1. Remove the protective caps from the SFP module and from the fibre channel c

DANGERSome laser products contain an embedded Class 3A or Class 3B laser diode. Note the following. Laser radiation when open. Do

OUTIN!2 Gb/s1 Gb/sOUTIN!2 Gb/s1 Gb/sOUTIN!2 Gb/s1 Gb/sOUTIN!2 Gb/s1 Gb/sOUTIN!2 Gb/s1 Gb/sOUTIN!2 Gb/s1 Gb/sOUTIN!2 Gb/s1 Gb/sOUTIN!2 Gb/s1 Gb/sHost 1

Drive interface ports DS4500 Storage Subsystems use only redundant drive-loop configurations. Each drive mini hub connects to Controlle

Overview: Cabling a DS4500 with four drive mini hubs Review the following information carefully and then continue to “Configuring th

Drive Loop ADrive Loop BDrive Loop DDrive Loop CInputInputOutput OutputFirst DS4000 driveenclosureLast DS4000 driveenclosureNew DS4000 driveenclosureD

Attention: Previous DS4500 cabling documentation identified incorrectly the connections of drive loops B and C in DS4500 configuratio

swapping these mini-hubs, you will not need to schedule down time later for re-cabling the drive loop if additional mini hubs are